The short answer
PrimeWall Interior Solutions installs and removes wallpaper in Broadview Park, FL, an unincorporated community in Broward County. We focus on careful wall preparation for older block homes so new paper lies flat and stays put in South Florida humidity.
Broadview Park is a small unincorporated pocket of Broward County, about 8 miles southwest of our base in Fort Lauderdale. It is mostly made up of modest single-story houses on quiet residential streets, many of them built decades ago with concrete-block exterior walls and interior finishes that have been updated, patched and repainted several times since. For a wallpaper installer, that history is the main thing to plan for. Old layers of paint, leftover paste and earlier wallpaper are common, and getting those surfaces right is what makes a new pattern look crisp. PrimeWall Interior Solutions takes on Broadview Park projects of every size, from a single bathroom wall to a whole-house refresh.
What we usually find behind the paint
In houses of this age, it is common to peel back a corner and discover two or three generations of finishes. Sometimes a previous owner painted directly over vinyl paper. Other times the original plaster has hairline cracks, or the drywall in a remodeled kitchen meets older plaster at an uneven seam.
None of that is unusual, and all of it is fixable. The key is identifying it before any new paper goes on, because thin and glossy papers show every ridge and bubble underneath.
- Painted-over wallpaper that needs to be scored and stripped
- Glue residue that blocks primer from bonding
- Cracks at corners and around door frames
- Old anchor holes from shelving, TVs and curtain rods
Removing old wallpaper the slow, clean way
We start removal by testing a small area to see how the paper and paste behave. Strippable papers may pull away dry. Others need scoring and a warm soaking solution, applied in sections so the wall underneath never stays wet for long.
Once the paper is off, we wash away remaining adhesive. Skipping that step is one of the main reasons new wallpaper fails in Florida homes, since moisture in the air can reactivate old glue and cause seams to lift. After washing, we let the wall dry fully with the AC running before moving on.
Repair and priming before anything new goes up
With the old finish gone, we fill cracks, set patches and skim coat any rough sections. Sanding gives us a flat, even surface, and a wallcovering primer seals it. That primer evens out porosity so paste does not soak in unevenly, and it makes the next removal far easier, whether that is five or fifteen years down the road.
Block walls along exterior sides of the house can feel cool and slightly damp during the wettest part of the year, from May through October. We check moisture before hanging so the paper is not trapped against a wall that is still releasing it.
Ideas that suit Broadview Park houses
Smaller rooms in single-story homes respond well to the right pattern. A soft vertical stripe can make a low ceiling feel taller, and a mural on one bedroom wall can give a compact space real personality without overwhelming it.
- Accent wall behind a bed or along a dining nook
- Washable vinyl in kitchens and hall bathrooms
- Peel and stick in kids' rooms or rental units
- Ceiling paper in a small powder room for a surprise effect
- Grasscloth in a living room with steady air conditioning
A note on window walls and exterior corners
In many Broadview Park homes the bedroom and living room windows sit in the same block exterior wall, and those walls behave differently from interior partitions. They take the afternoon sun, they cool down overnight when the AC cycles, and in the rainiest months they can hold a little more moisture. Paper on those walls benefits from a breathable non-woven backing and a primer that resists mildew.
Window returns and corners are where wallpaper most often fails first, because edges are exposed and handled. We wrap corners with a small overlap instead of ending a strip exactly at the edge, and we seal the trimmed edges around frames so humid air does not work its way behind the paper. These small steps add a little time to the job and noticeably extend how long the finish looks fresh.
Getting started
The first step is a short visit where we measure, look closely at the wall condition and talk through your plans. You will know before the work begins whether the walls need light prep or deeper repair. After that, we schedule a day that works for you and keep the work area covered and tidy throughout.
Broadview Park is close to other places we serve regularly, including Lauderhill, Lauderdale Lakes, Wilton Manors, Oakland Park and North Lauderdale.